Diy 50 Ton Press. Press construction requires steel cutting and drilling. I have about a 20 foot section of i beam that i believe is about 3/8 and about 9x9 i was thinking of cutting it up and making a shop press with it.
I still have the unipunch ( for sale cheap!) i was pushing the limits as i needed over 30 tons to punch a 3/8 x 1' oblong through 3/8 plate mainly. Constructed out of high strength 3/8 steel with a 1.0 x 4.0 thick top die and 3.0 wide bottom die. Note at the bottom where the guy says:
Flat Top Adjustable Bottom V Die For The Swag 20 Ton Press Brake Kits, & The 40 & 50 Brakes This Simple Concept Allows You To Easily Adjust The Gap Between The Bottom V Die, By Loosening Two 5/16 Bolts And Siding The 3/8 Thick Laser Cut Plates In Or Out.
Build your own hydraulic forging press. I tried to set up my press, a 50 ton dake with a unipunch and i abandoned the idea after a few test punches. (1) questions & answers (4) hover image to zoom.
Paras Stainless Steel Motor Operated Hydraulic Press, Capacity:
The setup worked fine for thin material but in 1/4 plate it went off like a gun blast. 50 tons is nothing to mess with. When bending sheet metal with the rubber bars, it requires more power than with conventional press brakes with a vee die.
This Will Allow For Tighter Bends On Thinner Materi
Built a cart for it to roll around on. Here's my 30 ton air over hydraulic shop press. I found a very large cylinder and shortened it to have a 13 inch stroke.
About Hydraulic Diy Ton Press 20
See more ideas about hydraulic, homemade tools, metal working. Hello friends,today i make a hydraulic press machine using of 5 ton hydraulic bottle jack. Welder, grinder, level, small square.
Most People Seem To Like The Harbor Freight Ones.
You can also make fixtures for bending s. Hems offer various sized portable press options from 30 to 300ton depending on the make/model of the tracks and applications. For those of you that have big shop presses what i need to know is the thickness of the metal i need to use and the diameter of the support pins.
0 Comments