Diy Pcb Etching Solution. The reactants are simpler to handle and store than the “ferric chloride” or “hydrochloric acid + hydrogen peroxide” methods. Once you have etched the pcb, dilute the rest of the ferric chloride solution, and dispose of it carefully.
But that was not enough heating power to heat up some 330 ml of etching solution to the desired 45°c in reasonable time. I wouldn’t recommend making etching paste,. I put this container, “bain marie” style, in a pot of hot water on the kitchen stove and set it to somewhere between min and med to ensure everything would stay warm.
I Just Had To Readjust The Volumetric Proportions.
Container for etching the pcb. This involves the use of chemicals for your etching solution. The etching process is assisted by some slight agitation.
My Preferred Method Of Generating An Etch Resist Is As Follows:
Put the board in an etching solution: To start the process we will first gather all the vital ingredients or materials required for the pcb making. After the first etch, you should notice the solution starting to acquire a light green tint.
First, Put On The Rubber Gloves Before Placing Some Newspaper Pieces On The Bottom To Avoid The Spillover Of The Etching Solution On The Floor.
Now that our ink has been transferred to the copper clad board, we can begin etching. The hydrogen peroxide acts as an oxidizer allowing the acid to eat away the copper. The etching agent was ferric chloride bought from an electronics store.
But That Was Not Enough Heating Power To Heat Up Some 330 Ml Of Etching Solution To The Desired 45°C In Reasonable Time.
Print your board layout on a sheet of transparent paper: The etching solution is prepared by a volumetric mixture of 1:3 muriatic acid and hydrogen peroxide in consumer concentrations. Use pliers to take out the pcb and check if the entire unmasked area has been etched or not.
I Use A Piece Of Paper Towel Stuffed Into 1 Diameter Tube To Lightly Wipe The Copper Surface While Etching.
200g ferric chloride (fecl3) + 300ml nitric acid (hno3) + 100ml water (h20) quick alternative: This process is called etching. The reactants are simpler to handle and store than the “ferric chloride” or “hydrochloric acid + hydrogen peroxide” methods.
0 Comments