Diy Az El Rotator. 1) collect the antenna position using hmc5883 digital compas. We totally revised the project addressing many user, hardware, software, integration, production and support issues:
We’ve been using our portable satellite station 2.0 for some time now and it works great. This project is not available as a kit. I was searching for a az/el antenna tracker for my dish and all i found was quite expensive.
Over Two Dozen Years Ago I Had A Full Set Up For Working The Ham Radio Satellites Including Big Circularly Polarized Beams, Mast Mounted Preamps And A Yaesu G 5400 Az El Rotor.
Az/el controller for satellite antenna tracking. I'm also using an arduino with k3ng rotator controller firmware. This project is not available as a kit.
I Am Currently Working On A Azimuth And Elevation Controller To Accept The Output From The Linux Program “Predict” By Kd2Bd.
Tecom az / el antenna rotor (and controller) for $80. This link is listed in our web site directory since sunday feb 21 2010, and till today homebrew az/el rotor and controller has been followed for a total of 3360 times. You can see a lot of the thinking and background research that was conducted prior to v3 development in this thread.also in this wiki page you can also find a how to build the rotator, mechanical analysis and all documentation about the satnogs rotator.
We Totally Revised The Project Addressing Many User, Hardware, Software, Integration, Production And Support Issues:
This project is a homebrew azimuth and elevation (“az/el”) rotation system using my arduino rotator controller. I have got a working system but i am sure it needs some tweaking to make it more efficient. Diy az/el antenna rotator for under 150€.
8 Outputs For Antenna Control ;
First of all, you can find the stls of the 3d printed parts on thingiverse. While a commercial computer interface is available from yaesu, the satnogs project provides an open hardware design that is much cheaper. 80.0k members in the rtlsdr community.
The Controller Was Designed To Be Compatible With The Satpc32 Tracking Program And Should Work With Any Tracking Program That Supports.
This is an attempt to build an antenna rotator controller using arduino mega 2560 with a nice user interface showing the actual position of the antenna. It's basically a 6 cube with an opening back panel that will allow access. Then, set the rotator to 359 degrees az and 90 degrees el, press the cal button to store the other stop position in the pic program.
0 Comments